Tuesday, July 14, 2020

Bike Chain Bracelet

This bracelet happened when a customer came by with a bicycle chain. It was the whole chain.  It had been cleaned but I soaked it in spirits for a day or so and scrubbed it with a tooth brush to get all the old grease out. The end with the clasp was open as shown here but I had to cut the link off the other end. After grinding and smoothing the link down I fabricated the jump rings for both ends and soldered them on. the problem with doing a bracelet in steel is the rust that forms from the sweat and oils in the skin. The only finish I used on this one is wax.  Once the whole thing was given a brushed finish, I warmed up the bracelet and brushed on the wax so it would melt into all the joints. The customer was very happy with the way it turned out.  Not a complicated job but interesting!



www.jewelryartstudio.com

No comments:

Post a Comment