Wednesday, October 3, 2018

Silver Cups

Many years ago I went to 5 day beach parties for new years several years in a row.  During that time I started a tradition of making a new shot cup for the party. I have continued, over the years, to be interested in making silver cups. However not just for new years any more.  Sometimes for special occasions or gifts or just for the fun of it because I had an idea I wanted to exicute
Top left is the New Year Chaser.  This one was probably the most elaborate and complicated to make. It is a champagne cup on one end and a shot cup on the other. The double ended ball suspended in the middle "drops" when the cup is turned over, almost touching the point of the bottom cup but swinging clear.
On the right of the New Years Chaser is the Conch Cup.  Sea shells an sea life have always fascinated me (as you can tell by my website) This one is self explanatory but again, some tricky solder joins.  On of the most difficult things cannot even be seen in this shot.  The feet are tiny silver spirals that had to be soldered on near the end. Let's just say it's hard to solder something small to something big. 
 The Tornado cup and the Bubble cup are some of the early designs.  The tornado cup has gold balls swirling around the out side. This one proved to be difficult because it's one long piece of wire and that is one long solder joint to go top to bottom without any gaps or leaks and then soldering on the gold balls without re-flowing the whole thing was a challenge too. The "bubble" cup on the right was one of the first ones from the "beach party series".  I liked the idea of it looking like there is no bottom yet it holds a full once.  


The bubble cup on the left was done for the 4th of July. Again using the drilled out metal as a decorative design element.  I have used this technique on several jewelry pieces over the years.  On the right is a wedding cup done for a friend. They wanted lots of texture.  I like the little feet on this one


 This pair of shot cups are titled Scars and Strips
I used a course rasp file to get the texture on the out side and soldered on the copper and silver stripes cut from long strips of this material I made years ago for earrings and bracelet. That in it self is a good blog post.  Its a pretty involved process of soldering and rolling. These 2 were done for the fun of it but have been sold.

I used this "box making" technique to go a step further and make a tea ball.  I wrote a blog post on that one here.
 I don't have any of these on my Etsy store or website but if your interested in on just comment here or contact me  through the website 

1 comment:

  1. Mary and I actually own a couple of the very early ones. Still our go to shot glasses for celebrations. It's nice to see the tradition continue.

    ReplyDelete